"File setupdd.sys could not be loaded. The error code is 4"
"File setupdd.sys could not be loaded. The error code is 7"
"File setupdd.sys could not be loaded. The error code is 14"
WHAT DO YOU DO AS SYSTEM ENGINEER
1.Shut down your computer, and then remove all the Peripheral Component Interconnect (PCI) devices.
2. Restart your computer.
If Windows starts successfully, shut down your computer, and then reinstall the PCI devices one at a time. Start Windows after the installation of each device. When you install a device that causes the issue that is described in the "Symptoms" section, remove that device, and then continue to install the other PCI devices.
If Windows does not start successfully, remove one or more of the memory modules that are installed in your computer. Leave sufficient RAM for your computer to start and run Windows XP.
Note Windows XP requires 128 megabytes (MB) RAM. The minimum is 64 MB and the maximum is 4 gigabytes (GB).
For example, if two 256-MB memory modules are installed in your computer, remove one of the memory modules. If Windows starts successfully, shut down the computer, and then reinstall the RAM modules one at a time. Start Windows after the installation of each RAM module. When you install a module that causes the issue that is described in the "Symptoms" section, remove that module, and then continue to install the other RAM modules.
